Example Configurations - GE PACSystems RX3i User Manual
Power sync and measurement system
Hide thumbs
Also See for PACSystems RX3i:
- User manual (169 pages) ,
- Command line interface manual (116 pages) ,
- Application manual (39 pages)
Table of Contents
Advertisement
3
Example Configurations
A portion of the PSM configuration is downloaded with the Proficy Machine Edition
hardware configuration (see "Configuration Parameters" on page 3-2). The remaining
details must be set, in the form of %Q bits, in application logic when the PLC goes to run
mode. Below are example configurations for typical applications.
Configuration for 120/240 VAC Single Phase System .................................................... 3-26
Configuration for 600VAC Single Phase System ............................................................ 3-29
Configuration for 120/208 WYE Three-Phase Four-Wire System ................................... 3-32
B-Common ....................................................................................................................... 3-35
C-Common ....................................................................................................................... 3-38
Configuration for 120/208 4-Wire WYE Synchro/Power Control Connection ................. 3-41
Configuration for 480V 4-Wire WYE Synchro/Power Control Connection ...................... 3-44
GFK-2749
Chapter 3 Configuration and Data Transfer
3-25
Advertisement
Table of Contents
