Installation; Electrical Connections; Dip Switch Settings - Webasto Pure Installation Instructions Manual

8.3

Installation

EN
See also "Assembly on page 22". The sup-
plied installation material is intended for
mounting the charging station on a concrete
wall or on an external stand. For installation
on a stand, the mounting material is in-
cluded in the scope of delivery of the stand.
Only use the supplied installation material to
install the mounting frame. See for an over-
view of the mounting frame.
See also Fig. 6
Legend
Mounting frame
Spirit level
Weak-spots for cable leadthroughs for sur-
face mounting the connection cable.
u Mark the 4 holes with the aid of the
mounting frame and spirit level.
Make sure that the holes are centred.
–
u Drill the 4 holes in the wall.
u Insert the wall plugs in the holes.
Prepare the mounting frame for the cable
u
installation:
Connection cable from rear:
–
feed the cable through the bottom part of
the frame.
Connection cable from top/left/right/bot-
–
tom:
remove the prepared weak-spots in the
frame.
18
Place the mounting frame in level posi-
u
tion.
u Secure the mounting frame with the 2
short screws and washers on the top
holes.
u Remove the bottom cover from the hous-
ing.
See also Fig. 7
u Feed the connection cable through the
opening in the lower part of the housing
and fix it with the rubber grommet sup-
plied in the scope of delivery.
Place the charging stations on the two
u
Hook to attach the
hooks at the top of the frame.
charging station
u Secure the bottom part of the charging
Prepared weak spot
station with the 2 long screws and wash-
ers.
8.4

Electrical connections

The connection terminals are alligator
–
clips.
Depending on the cable and type of in-
–
stallation, the minimum cable cross-sec-
tion for a standard installation is 6 mm²
(for 16 A) and 10 mm² (for 32 A).
NOTE
Use wire end ferrules in case of flex-
ible connection cable.
Feed the connecting cable through the
u
rubber grommet into the centre of the
charging station housing, straight and
without tension. See also "Installation on
page 18".
u Route the connection cable with the cor-
rect radius (approx. cable diameter x10) to
the connection terminals.
u Cut the wires to the correct length. Keep
the connections as short as possible. The
PE conductor should be longer than all
the other wires.
u Strip the wires to a length of 12 mm.
u Check whether the power supply is 1-
phase or 3-phase.
1-phase: Use only L1, N and PE.
–
3-phase: Use L1, L2, L3, N and PE. Then
–
measure the phase order.
NOTE
A clockwise phase order is required.
u Secure the wires to the connection ter-
minals as illustrated.
See also Fig. 8
u Check that the connections are tight and
connection cable is secure.
8.5

DIP switch settings

DANGER
High voltages.
Danger of fatal electric shock.
u
u Ensure safe isolation from the power sup-
ply.
5110159D Webasto Pure