12
Standard vs. Extended Position
There are two positions that the standoff/heat shield assembly can be installed. The standoffs are
shipped in the standard (forward) position.
If the unit is installed in the standard position no modification is needed.
If the unit is being installed in the extended position, the standoff/heat shield assembly must
be repositioned back 1/2" (13mm) (see illustration below).
NOTE: see pages 10 & 34.for additional details about standard vs. extended installations.
© Travis Industries
Installation
(for qualified installers only)
Extended Position
Standard Position
12/17/20 - 1528
PB24 CF Install (AUST)