Table of Contents
Advertisement
Figure 7. Front view of server model with ten 2.5-inch drive bays
Table 4. Components on the front of the server
VGA connector (optional)
1
USB 3.2 Gen 1 (5 Gbps) connectors
3
Rack latch (right)
5
Drive status LED (yellow)
7
Rack latch (left)
9
VGA connector
1
Used to attach a high-performance monitor, a direct-drive monitor, or other devices that use a VGA
connector.
Pull-out information tab
2
The ThinkSystem System Manager network access label is attached on the pull-out information tab. The
default ThinkSystem System Manager hostname and the IPv6 Link Local Address (LLA) are provided on the
tab.
3
USB 3.2 Gen 1 (5 Gbps) connector
Attach a USB-compatible device, such as a USB keyboard, USB mouse, or USB storage device.
Operator information panel
4
For information about the controls and status LEDs on the operator information panel, see "Operator
information panel" on page 15.
5 9
Rack latches
If your server is installed in a rack, you can use the rack latches to help you slide the server out of the rack.
You also can use the rack latches and screws to secure the server in the rack so that the server cannot slide
out, especially in vibration-prone areas. For more information, refer to the Rack Installation Guide that comes
with your rail kit.
6
Hot-swap drive bays(drive fillers are installed for no-backplane configuration)
The number of the installed drives in your server varies by model. When you install drives, follow the order of
the drive bay numbers.
The EMI integrity and cooling of the server are protected by having all drive bays occupied. The vacant drive
bays must be occupied by drive fillers.
Drive status LED
7
ThinkSystem SR635 Maintenance Manual
14
Pull-out information tab
2
Operator information panel
4
Hot-swap drive bays
6
Drive activity LED (green)
8
Drive bay filler
10
Advertisement
Table of Contents
