Fuse Replacement; Troubleshooting - ADJ ENCORE PROFILE 1000 WW User Manual

Encore Profile 1000 WW
This fixture is capable of being linked to other fixtures of the same model type by connected
the locking power input and output sockets together in series.
The maximum number of fixtures that can be connected in this manner is 5 fixtures.
After this quantity has been reached, a new power outlet will be needed in order to accommo-
date additional fixtures. All linked fixtures must be of the same make and model type. DO NOT
mix fixtures!
Encore Profile 1000 WW
Disconnect the unit from its power source. Remove the power cord from the unit, and locate the fuse
holder above the power connection. Use a phillips head screwdriver to remove the fuse holder, then
remove the fuse located inside the fuse holder and replace with a new fuse. Reinstall the fuse holder
and secure it in place.
Encore Profile 1000 WW
Listed below is a common problem the user may encounter, with a potential solution.
Unit not responding to DMX:
Check that the DMX cables are connected and wired correctly (pin 3 is "hot"; on some other DMX
devices pin 2 may be "hot"). Also, check that all cables are connected to the correct connectors; the
order in which the inputs and outputs are connected can affect the operation of the fixture.
Encore Profile 1000 WW
Due to fog residue, smoke, and dust, cleaning the internal and external optical lenses must be car-
ried out periodically in order to optimize light output.
• Use normal glass cleaner and a soft cloth to wipe down the outside casing.
• Clean the external optics with glass cleaner and a soft cloth every 20 days.
• Always be sure to dry all parts completely before plugging the unit back in.
Cleaning frequency depends on the environment in which the fixture operates (i.e. smoke, fog resi-
due, dust, dew).
ADJ Products, LLC - www.adj.com - Encore Profile 1000 WW User Manual Page 17
Power Cord Daisy Chain

Fuse Replacement

Trouble Shooting
Cleaning