Fuse Replacement | Cleaning | Trouble Shooting - ADJ Startec Series User Manual

Disconnect the unit from its power source, then remove the power cord from the unit. Locate the
fuse holder inside the power socket, then insert a flat-head screw driver into the power socket and
gently pry out the fuse holder. Remove the bad fuse and replace with a new one. Please note that
the fuse holder also contains a slot for holding a spare fuse.
Due to fog residue, smoke, and dust, cleaning the internal and external optical lenses and mirror
should be carried out periodically in order to optimize light output. Cleaning frequency depends on
the environment in which the fixture operates (I.e. smoke, fog residue, dust, dew). In heavy club use,
cleaning on a monthly basis is recommended, and such periodic cleaning will ensure fixture longev-
ity and crisp output.
• Use normal glass cleaner and a soft cloth to wipe down the outside casing.
• Use a brush to wipe down the cooling vents and fan grill.
• Clean the internal and external optics and mirror with glass cleaner and a soft cloth on a regular
basis.
• Always be sure to dry all parts completely before reassembling the unit and plugging it back in.
Listed below are a few common problems may occur, along with potential solutions.
No light output from the unit:
• Check that the external fuse has not blown. The fuse is located on the rear panel of the unit.
• Check that the fuse holder is fully and properly seated.
Unit does not respond to sound:
• Low frequencies (bass) will trigger the sound active reaction. Tapping on the microphone or quiet
or high pitched sounds may not activate the unit.
• Check that sound sensitivity is enabled, and adjust if necessary.
FUSE REPLACEMENT
CLEANING
TROUBLE SHOOTING
23