Focus And Zoom Adjustments - ADJ ENCORE PROFILE 1000 WW User Manual

Encore Profile 1000 WW
Gamma:
This feature is predominately used when shooting video. Adjust the gamma setting to clean up any
lines that might be seen on camera.
1. Plug the fixture in and press the MODE button until "GAMMA" is displayed. The current gamma
setting will be displayed.
2. Use the UP and DOWN buttons to switch the gamma setting.
Fan Speed:
This will let you set your desired fan speed.
1. Plug the fixture in and press the MODE button until "FAN SPEED" is displayed, and press ENTER.
2. Use the UP and DOWN buttons to switch between the different fan speeds.
Refresh Rate:
This feature is predominately used when shooting video. Adjust the frequency setting to clear up any
LED flicker that might be seen on camera.
1. Plug the fixture in and press the MODE button until "FREQUENC" is displayed. The current fre-
quency setting will be displayed.
2. Use the UP and DOWN buttons to switch the frequency setting.
PCB Temperature:
This will check the current temperature of unit as well as switch between fahrenheit and celsius.
1. Plug the fixture in and press the MODE button until "OTHER MODE" is displayed.
2. Press the SET UP button until "TEM:XXXX" is displayed.
3. Use the UP and DOWN buttons to switch between fahrenheit and celsius.
Encore Profile 1000 WW
The knobs located on the right side of unit are used to adjust the focus and the zoom. For a tighter/
narrow beam move the first/front knob towards the front of the fixture, and move the second knob
towards the rear. For a wider beam, move the first/front knob towards the middle of the fixture, and
move the second knob towards the middle as well. Adjust accordingly.
ADJ Products, LLC - www.adj.com - Encore Profile 1000 WW User Manual Page 10
Operating Instructions

Focus and Zoom Adjustments