Table of Contents
Advertisement
3 Sixty 2R
Channel
Value
32
LAMP ON/OFF, RESET & PROGRAMS
120 - 139
140 - 159
160 - 179
180 - 199
200 - 219
220 - 239
240 - 255
The pan degree can be changed between 540° and 630°. See
page 28 to change the pan degree.
3 Sixty 2R
50460
Intensity LUX
2
1
0
1
2
10
0.62
ADJ Products, LLC - www.adj.com - 3 Sixty 2R Instruction Manual Page 64
32 Channel DMX Mode
Function
INTERNAL PROGRAM 2
INTERNAL PROGRAM 3
INTERNAL PROGRAM 4
INTERNAL PROGRAM 5
INTERNAL PROGRAM 6
INTERNAL PROGRAM 7
SOUND ACTIVE PROGRAM
Photometric Chart
21850
12710
4
15
20
Distance(m)
0.93
1.24
Diameter(m)
3 Sixty 2R
Caution:
Always replace with the exact same type lamp and fuse, unless
otherwise specified by an authorized ADJ service technician. Replacing
with anything other than the specified part can damage your unit and will
void your manufactures warranty.
Warning:
If you continue to blow lamps or fuses, STOP using the unit.
Contact customer support for further instructions, you may have to return
the unit for servicing. Continuing to use the unit may cause serious damage.
Lamp Replacement:
Caution! Never attempt to change the lamp
while the fixture is plugged in. Always disconnect the main power
and allow the unit ample time to cool before attempting to replace
the lamp. Please see page 7 for important information regarding the
discharge lamp.
1. Be sure to follow the proper handling procedures that deal with
discharge lamps.
2. Remove the four small screws (labeled A, B, C, & D) on the rear of
the moving head.
3. After removing the screws, gently remove the panel.
4. Carefully disconnect the two wires connected to the lamp (Pic A).
5. Next, squeeze the lamp holding clips togther and lift the holder
(Pic B).
6. Replace the lamp with an exact match. Reassemble in reverse
order.
Pic A
Fuse Replacement: Locate and remove the unit's power cord. Once
the cord has been removed located the fuse holder located inside the
power socket. Insert a flat-head screw driver into the power socket
and gently pry out the fuse holder. Remove the bad fuse and replace
with a new one. The fuse holder has a built-in socket for a spare fuse
be sure not to confuse the spare fuse with active fuse.
ADJ Products, LLC - www.adj.com - 3 Sixty 2R Instruction Manual Page 65
Lamp Replacement
Pic B
Advertisement
Table of Contents
