Photometric Chart / Fuse Replacement / Cleaning; Trouble Shooting - ADJ H2O IR User Manual

With the power cord removed, locate the units fuse holder which is located on the power input
socket. With a flat head screw driver, gently remove the fuse holder. Remove the bad fuse and
replace with a slow blow fuse of the same amperage. The fuse holder has a built-in socket for a
spare fuse. Be sure not to confuse the spare fuse with active fuse.
Warning: If after replacing the fuse you continue to blow fuses, STOP using the unit. Contact cus-
tomer support for further instructions. Continuing to use the unit may cause serious damage.
Fixture Cleaning: Due to fog residue, smoke, and dust, cleaning the internal and external lenses
should be carried out periodically to optimize light output.
1. Use normal glass cleaner and a soft cloth to wipe down the outside casing.
2. Clean the external optics with glass cleaner and a soft cloth every 20 days.
3. Always be sure to dry all parts completely before plugging the unit back in.
Cleaning frequency depends on the environment in which the fixture operates (I.e. smoke, fog resi-
due, dust, dew). During heavy use, it is recommended to clean the unit every 30 days. Periodic
cleaning will ensure longevity, and crisp beam output.
No light output from the unit
1. Ensure that power cord is properly connected to the unit and to a power source.
2. Ensure the fuse has not blown. The fuse is located on the rear panel inside the power socket.
See Fuse Replacement.
PHOTOMETRIC CHART
FUSE REPLACEMENT
CLEANING

TROUBLE SHOOTING

11