Configuring And Setting Parameters - Bosch IO-BOX32 Manual

5–4
7-segment displays
5.1.3

Configuring and setting parameters

The 7-segment displays show:
D the set bus address
D Errors that have led to a system halt
up to
In the case of a system halt,
D the outputs of the IO-BOX32 are place in the safe state ("0")
D the bus traffic to the bus master is discontinued
A system halt can only be cancelled by means of "power off". In this case,
contact Bosch Service.
A DP configuration program (DP configurator) is required for configuration
and setting of parameters.
The DP configurator is used to:
D set parameters for the IO-BOX32-DP
D create the target configurations
D assign the PLC addresss to the decentralised inputs and outputs
D set the bus parameters
D display diagnosis information
D evaluate the GSD data
.
WinDP is used for Bosch control systems. For the operation of
a DP bus master
corresponding DP configuator must be used.
assembly from another manufacturer, the
1070 072 302-101 (01.06) GB