Operation With Profibus-Dp; Rotary Switch For Bus Address - Bosch IO-BOX32 Manual

5

Operation with PROFIBUS-DP

5.1

Rotary switch for bus address

1070 072 302-101 (01.06) GB
The rotary switches for setting the bus address are located beneath the
housing cover.
Each IO-BOX32-DP must be assigned its own bus participant address. This
may only be assigned once in the entire PROFIBUS-DP. The bus participant
address is set using rotary switches. Addresses 0 and 1 are reserved and
therefore not permitted.
.
Shipped state: Address 2
Bus address
ten positions
Set the bus address. To do so, use a small screwdriver to turn the
L
arrow-shaped recess into the right position. The rotary switch must click into
place.
D The set bus address is shown in the 7-segment display.
D A bus address that is changed during operation only takes effect after
a new 'power on'.
High Low
5–1
Bus address
one position