*Assemble with Loctite '35'. A rotational free play NOT EXCEEDING .127 mm (005 in.) between the
hub and shaft measured at the wheel stud MUST be used for LEFT HAND hubs.
**Tighten nut to this torque loading while rotating the hub to ensure bedding of taper rollers. Slacken
nut 'one flat', then insert split pin.
BRAKE HYDRAULIC SYSTEM CONNECTIONS
3/8 in UNF female (bundy and hose connection)
3/8 in UNF male (bundy to master cylinder,
multi-ways etc.)
7/16 in. UNF male
3/8 in. bore servo bundy (5/8 in. male)
Stop lamp switch
Brake hose to banjo
7/16 in. UNF female (bundy to reservoir)
Torque Wrenches
Torque wrenches in daily use should be checked at intervals not exceeding 3 months to ensure that
accuracy is maintained.
----------------------------------------------------------------------------------------Section Updated: 6/27/2009 9:01 AM at http://www.lotus-europa.com ----------------------------------------------------------------------------------------