Service And Repairs; Groomer Belt Replacement - Toro Reelmaster 5500-D Service Manual

Service and Repairs

Groomer Belt Replacement

The groomer drive belt should be inspected/replaced
annually or after 750 hours of operation.
1. Park machine on a clean and level surface, lower
cutting units completely to the ground, stop engine, en-
gage parking brake and remove key from the ignition
switch.
2. Remove two (2) flange nuts that secure groomer belt
cover, then remove cover (Fig. 2).
3. Lift idler pulley to relax belt tension. Slip groomer
drive belt off pulleys (Fig. 3). Carefully release idler
pulley.
4. Install new drive belt to drive pulley, idler pulley and
driven pulley observing correct belt routing (Fig. 3).
Make sure that idler pulley is above groomer drive belt
after belt installation.
5. Install belt cover and secure with two (2) flange nuts.
Reelmaster 5500−D
1. Groomer belt cover
3
1. Drive pulley
2. Idler pulley
Page 8.1 − 5
1
2
Figure 2
2. Flange nut
2
4
Figure 3
3. Driven pulley
4. Groomer drive belt
Groomer (Rev. C)
2
1