Muffler Removal And Installation - Toro Reelmaster 5500-D Service Manual

Muffler
1. Muffler
2. Muffler bracket
3. Cap screw
4. Flat washer
5. Muffler clamp
6. Lock nut
7. Exhaust pipe
Muffler Removal
CAUTION
The muffler and exhaust pipe may be hot. To
avoid possible burns, allow the engine and ex-
haust system to cool before working on the muf-
fler.
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake, and remove key
from the ignition switch.
2. Remove muffler and/or muffler bracket from the en-
gine as necessary using Figure 17 as a guide.
Reelmaster 5500-D
5
7
15
17
16
8
17
9
11
12
10
21
13
19
Figure 17
8. Flat washer
9. Muffler clamp
10. Manifold flange
11. Lock nut
12. Lock washer
13. Lock nut
14. Flywheel guard
Page 3 - 11
1
3
4
20
2
4
6
15
12
14
20
12
15
12
18
15. Cap screw
16. Cap screw
17. Lock washer
18. Temperature sender
19. Stud
20. Cap screw
21. Manifold flange gasket
Muffler Installation
1. Install muffler and/or muffler bracket to the engine
using Figure 17 as a guide.
Note: If manifold flange is removed, reinstall using a
new manifold flange gasket. Make sure sealing surfaces
are free of debris or damage that may prevent a tight
seal.
Kubota Diesel Engine