Keysight X Series Installation Note page 9

1CC150A - Additional SSD Drive Installation
1. Disconnect the power cord.
2. Refer to Figure 4. Remove the Solid State Drive (1) by using the T-15 driver to loosen the
thumb screws where indicated and pulling out of the rear panel.
Figure 4 SSD Removal
3. Install the new SSD tray by sliding the tray into the rear panel opening. Press to mate with the
connectors. Secure by tightening the thumb screw. Torque to 9 in-lbs.
4. Connect the power cord and turn the instrument on. There should be no errors.
Installation Note N5191-90025
1CC150A - Additional SSD Drive Installation
9