Keysight X Series Installation Note page 6

Agile signal generators

Hide thumbs Also See for X Series:

1CC145A - Empty Drive Tray Accessory Installation

The empty drive tray can be used in two ways:

— If no SSD is desired in the instrument.For security reasons, some lab areas do not permit

removable mass storage devices in instruments.

— For a customer purchased SSD installation.

1. Disconnect the power cord.

2. Refer to

Figure

1. Remove the Solid State Drive (1) by using the T-15 driver to loosen the

thumb screws where indicated and pulling out of the rear panel.

Figure 1

SSD Removal

This drive tray is designed to carry a 2.5-inch solid state drive (SSD). If you are installing an SSD

from a third-party manufacturer, the SSD must have a SATA III 6Gb/s interface and an operating

temperature range equal to or greater than the operating temperature range of the instrument.

Only drives purchased from Keysight Technologies are covered under warranty. Keysight does not

warrant third party supplied hardware or software including third party SSDs.

Installation Note N5191-90025