Driveshaft Housing Installation - Mercury 15 EFI FourStroke Service Manual

11. Remove one screw to remove the water pump indicator tube.
a

Driveshaft Housing Installation

1. Using one screw, attach the water pump indicator tube to the driveshaft housing. Tighten the screw to the specified torque.
a
Description
Screw
2. Install the rubber seal onto the driveshaft housing.
3. Install the driveshaft seal.
4. Install the powerhead gasket.
d
c
b
a
5. Install the driveshaft housing onto the steering arm.
90-8M0125265 eng NOVEMBER 2017
Clamp/Swivel Bracket and Driveshaft Housing
a - Water pump indicator tube
b - Screw
b
64268
a - Water pump indicator tube
b - Screw
b
64268
a - Powerhead gasket
b - Dowel pin
c - Driveshaft seal
d - Rubber seal
64101
© 2018 Mercury Marine
Nm lb‑in.
6.0 53.1
Page 5A-47
lb‑ft
–