Outboard Installation
Lubricants, Sealants, Adhesives
Tube Ref No.
2-4-C with PTFE
95
Start in Gear Protection
Starting the engine with the drive in gear can cause serious injury or death. Never operate a boat that does not have a
neutral‑safety‑protection device.
The remote control connected to the outboard must be equipped with a start in neutral only protection device. This prevents the
engine from starting in gear.
Lifting the Outboard
Use the lifting eye on the engine.
Installing Outboard
Boat Transom Height Requirement
Measure the transom height of your boat. The boat bottom should be aligned or be within 25 mm (1 in.) above the
antiventilation plate of the outboard.
a
Installing Outboard on Transom
Failure to correctly fasten the outboard could result in the outboard propelling off the boat transom resulting in property
damage, serious injury, or death. Before operation, the outboard must be correctly installed with the required mounting
hardware.
Page 1D-2
Description
a -
27151
© 2018 Mercury Marine
Where Used
Steering cable end
WARNING
!
Antiventilation plate
WARNING
!
92-802859A 1
62883
90-8M0125265 eng NOVEMBER 2017
Part No.