Isdn Bri Special Hunting - Nortel Communication Server 1000S Installation And Configuration Manual

nnn = feature indication ID (0 - 127) (If nnn is not entered, it is assumed
to be the same as mmm)
3 On the ISDN BRI terminal, if the signaling type/protocol is configurable,
then select National ISDN-1or ETSI protocol.
4 On the ISDN BRI terminal, configure Conference. This procedure
largely depends on the implementation of feature key management on
individual terminals. In general:
a. The terminal provides Conference as a selectable feature to be
programmed on a hard/soft key. For example, on a soft key on an
M5317TDX, select FA to be FCC; on a hard key on an M5209TDcp,
select CONF.
b. The Conference key number selected on the terminal must
correspond to the feature activation ID entered for the TSP in LD 27.
5 Configure at least two DN appearances on the ISDN BRI terminals. On
some ISDN BRI terminals, the second DN appearance is used to allow
the user to initiate the second call.
6 Place an outgoing call from the ISDN BRI terminal.
7 After the first call is established, place an incoming call to the ISDN BRI
terminal.
8 Hold the first call and answer the second call.
9 Press the Conference key; the second call is put on hold.
10 Retrieve the first call and press the Conference key again. All three
parties should be in a conference.
11 Press the RELEASE key to drop from the call. The ISDN BRI user
should be disconnected from the conference; the remaining two parties
should still be connected, except for two outgoing trunk calls, in which
case all parties should be disconnected.

ISDN BRI Special Hunting

ISDN BRI Special Hunting allows a call encountering a destination that has
a call in progress to be automatically routed to a different destination in a hunt
chain. Hunting continues along a predetermined sequence of DNs in a
hunting group until an idle ISDN BRI or non-ISDN BRI terminal DN is found
Testing ISDN BRI functions
ISDN Basic Rate Interface
Page 107 of 120
Installation and Configuration