Nortel Communication Server 1000S Installation And Configuration Manual page 106

Page 106 of 120
553-3001-218 Standard 2.00
Testing ISDN BRI functions
4 On the ISDN BRI terminal, configure Conference. This procedure
largely depends on the implementation of feature key management on
individual terminals. In general:
a) The terminal provides Conference as a selectable feature to be
programmed on a hard/soft key. For example, on a soft key on
an M5317TDX, select FA to be FCC; on a hard key on an
M5209TDcp, select CONF.
b) The Conference key number selected on the terminal must
correspond to the feature activation ID entered for the TSP in
LD 27.
5 Configure at least two DN appearances on the ISDN BRI terminal. On
some ISDN BRI terminals, the second DN appearance allows the user to
initiate the second call.
6 Place an outgoing call from the ISDN BRI terminal.
7 After the call is established, press the Conference key. The first call is
put on hold automatically; a second key is lit to allow the user to place
the second call.
8 Place another outgoing call from the second key.
9 After the second call is established, press the Conference key again to
bridge the two calls. All three parties should be in a conference.
10 Press the RELEASE key to drop from the call. The ISDN BRI user
should be disconnected from the Conference; the remaining two parties
should still be connected, for two outgoing trunk calls, in which case all
parties should be disconnected.
Procedure 32
Perform a Call Join test on Conference
1 In the DSL configuration in LD 27, set PRID = 6 to select the National
ISDN-1 protocol, or PRID = 2 for ETSI protocol.
2 In the TSP configuration in LD 27, define conference under FEATID:
FEATID aaa mmm <nnn>, where
aaa = A03 (3-party conference) or A06 (6-party conference)
mmm = feature activation ID (0 - 127)
September 2004