Table of Contents
Advertisement
BL600-Sx Hardware Integration Guide
Single Mode BLE Module
13.1 General Comments
This is a preliminary datasheet. Please check with Laird for the latest information before commencing a design.
If in doubt, ask.
14 B
SIG Q
LUETOOTH
The BL600 module is listed on the Bluetooth SIG website as a qualified End Product.
Design
Owner
Name
BL600
Laird
Technologies
BL600*
Laird
Technologies
(* Modules with firmware v1.5.x.x)
It is a mandatory requirement of the Bluetooth Special Interest Group (SIG) that every product implementing
Bluetooth technology has a Declaration ID. Every Bluetooth design is required to go through the qualification
process, even when referencing a Bluetooth Design that already has its own Declaration ID. The Qualification
Process requires each company to registered as a member of the Bluetooth SIG –
The following link provides a link to the Bluetooth Registration page:
https://www.bluetooth.org/login/register/
For each Bluetooth Design it is necessary to purchase a Declaration ID. This can be done before starting the
new qualification, either through invoicing or credit card payment. The fees for the Declaration ID will depend
on your membership status, please refer to the following webpage:
https://www.bluetooth.org/en-us/test-qualification/qualification-overview/fees
For a detailed procedure of how to obtain a new Declaration ID for your design, please refer to the following
SIG document:
https://www.bluetooth.org/DocMan/handlers/DownloadDoc.ashx?doc_id=283698&vId=317486
To start the listing, go to:
In step 1, select the option, Reference a Qualified Design and enter 20700 or 23023 in the End Product table
entry. You can then select your pre-paid Declaration ID from the drop down menu or go to the Purchase
Declaration ID page, (please note that unless the Declaration ID is pre-paid or purchased with a credit card, it
will not be possible to proceed until the SIG invoice is paid.
Once all the relevant sections of step 1 are finished, complete steps 2, 3, and 4 as described in the help
document. Your new Design will be listed on the SIG website and you can print your Certificate and DoC.
For further information please refer to the following training material:
https://www.bluetooth.org/en-us/test-qualification/qualification-overview/listing-process-updates
Americas: +1-800-492-2320 Option 2
Europe: +44-1628-858-940
Hong Kong: +852-2923-0610
www.lairdtech.com/bluetooth
UALIFICATION
Declaration
Link to listing on the SIG website
ID
B020700
https://www.bluetooth.org/tpg/QLI_viewQDL.cfm?qid=20700
D023023
https://www.bluetooth.org/tpg/QLI_viewQDL.cfm?qid=23023
https://www.bluetooth.org/tpg/QLI_SDoc.cfm
49
www.bluetooth.org
CONN-HIG-BL600
Advertisement
Table of Contents
