Table of Contents
Advertisement
3.7
How to Take a Still Image of the RX Monitor
After the installation, take a still image of the RX monitor screen in a harbor test. The
still image of the RX monitor screen is used for checking the equipment in mainte-
nance.
1. Click the [Settings] icon (
vanced Settings] icon (
2. Select the [Tests] from the menu on the left-hand side of the window. The [Tests]
menu appears on the right-hand side of the window.
3. Select the [Rx Monitor] from the [Tests] menu.
The RX monitor screen appears.
4. Select the beam to be displayed at the drop-down box on the screen.
• [SB]: Split beam
• [B1] to [B5]: Beam 1 to Beam 5
• [Rx Test]: Receiving test
5. Press the wheel on the trackball to take a still image.
6. Click the [Close] button to close the RX monitor screen.
7. Press and hold the scrollwheel on the trackball control unit to open the replay
screen, then confirm that the still image that of the RX monitor screen is saved cor-
rectly.
3.8
Reset to Default Setting
To reset all customized settings for advanced setting menus and external sounder set-
ting menus to their default settings. The external echo sounder setting should be reset
before the reset of main system setting. Do the following procedure.
Note: Customized settings cannot be restored. If necessary, write the settings down.
) from the InstantAccess bar, then click the [Ad-
).
3. INITIAL SETTINGS
[Close]
button
Select the
appropriate
beam.
3-19
Advertisement
Table of Contents
