Table of Contents
Advertisement
3. INITIAL SETTINGS
3. Change to the IP address of the FCV-38 as shown in the figure below. The default
IP address of the FCV-38 is "172.31.2.9". If the IP address is not changed from
the default, enter the default value, and then click [Apply].
4. When the IP address is changed properly, the message "IP setting is completed."
appears above the progress bar. Click [Quit] to quit the tool.
5. The following message appears. Click [OK].
Note: You do not have to change the Subnet mask.
3-22
Information
Please set the IP address/subnet mask for Processor unit.
IP address of FCV-30
transceiver unit
Enter IP address of
FCV-38.
OK
Advertisement
Table of Contents
