Table of Contents
Advertisement
3. INITIAL SETTINGS
Reset the external sounder settings
1. Move the cursor to the external echo picture on sub monitor, and right-click on the
screen.
2. Select [Service] from the menu, then press and hold the [OK] button for approxi-
mately ten seconds. The [Service] menu is expanded.
3. Select [Restore Default Settings] at the left bottom corner of the window.
The message window appears as shown below.
FCV-38[ver 0252473-xx.xx]
4. Select [Yes] to restart the system.
Reset the main system advanced settings
1. Select the [Advanced Settings] icon (
lect the [Advanced Settings] icon (
2. Select [Service] from the menu and press and hold the [OK] button for approxi-
mately ten seconds. The [Service] menu is expanded.
3. Select [Restore Default Settings] at the left bottom corner of the window.
The message window shown above appears.
4. Select [Yes] to restart the system.
3.9
Retrofit from FCV-30
If the transceiver unit of the FCV-30 is connected to the processor unit of the FCV-38,
the IP address of the FCV-30 must be changed. To change the IP address, the IP ad-
dress changing tool is required.
3.9.1
Required Tools and Device
• PC: Windows
• upip.exe file: IP address changing tool. Install it on a PC (It can be installed on the
Desktop). For this tool, contact your dealer.
• LAN cable
3-20
®
10 (64 bit)
) from the InstantAccess bar, and se-
) from the expanded menu bar.
Advertisement
Table of Contents
