Table of Contents
Advertisement
1. MOUNTING
Data sheet sticker
The transducer is supplied with three data sheet stickers in silver on the transducer
cable as follows. Refer to section 3.2.6.
[CV-303 15M] sticker
(Attached on the base of
the transducer)
Note: If the data sheet stickers in white (Not in silver) are attached on the cable for
FCV-30, conductive tape should be wound around the exposed shield. See
section 2.4 for details.
1.4.1
About transducer casing
The FURUNO transducer tank is finished with lacquer primer to prevent corrosion in
storage. After welding the casing to ship's hull, remove the lacquer primer, using lac-
quer thinner. Coat casing with same paint as used on the ship's hull.
Methods to remove lacquer primer from the tank
1. Dissolve and remove paint with solvent.
2. Remove rust, coating, oil film, etc, with a blaster.
3. Remove with a disk sander or foil brush.
1.4.2
Transducer fixing plate kit (option) assembly
You can use the optional T-625-A transducer fixing plate kit to reduce noise caused
by ship movement for transducer tank T-625 (local supply).
1. Remove the press plate from the transducer fixing plate and fit the fixing plate to
the transducer.
1-8
[TRANSDUCER DATA] sticker (2pcs.)
(Attached near the connectors )
Press plate
Transducer fixing plate
Transducer
Be careful of bow direction.
Be careful of bow direction.
Advertisement
Table of Contents
