Table of Contents
Advertisement
TTYCSLA cable
Armor
Vinyl tape
<How to connect wires to a terminal connector>
2.1.4
How to change the fuse
Change the fuse in the fuse holder on the power cable
according to the input voltage, referring to the following
table. Fuses are supplied as spare parts.
Input voltage
12 VDC
24 VDC
Inner sheath
Pass a heat shrinkable tube (supplied locally) onto the drain wire.
Attach a crimp-on lug (FV1.25-3, supplied locally) to the core.
Press downward.
Terminal
opener
Terminal
connector
Twist
15 A (factory default)
WARNING
WARNING
Use the proper fuse.
Fuse rating is shown in the table below.
Use of a wrong fuse can result in
damage to the equipment.
495 mm
495 mm
450 mm
450 mm
Drain wire
Drain wire
6 mm
6 mm
80 mm
80 mm
6 mm
6 mm
Procedure
1. Twist the cores.
2. Press the terminal opener
downward.
3. Insert the wire in the hole.
4. Remove the terminal
opener.
5. Pull the wire to confirm
that it is secure.
Rating of fuse
7 A
2. WIRING
Fuse holder
Power cable
2-5
Advertisement
Table of Contents
