Table of Contents
Advertisement
plied USB cable is connected to USB3.0 port on the processor unit. However, the data
transfer speed is equivalent to USB 2.0.
Note 4: If the USB cable will not be connected to the trackball control unit, attach the
supplied USB sheet to the USB port on the trackball control unit.
How to extend the control unit cable
To extend the length of the cable between the trackball control unit and the processor
unit, use the optional cable assembly (6TPSH-XH12X2-LxxSP2, 5/10 m).
1. Unfasten four binding screws (M3×8) from the bottom of the unit, and a pan head
screw (M3×8) and flat washer from the back of the unit to remove the cover.
Note: Remove the cover slowly to prevent damage to the cables connected to the
circuit board in the unit.
Binding screw (M3×8, 4 pcs)
Control unit cover
USB sheet:
Attach this sheet when the USB cable
between the trackball control unit and
processor unit is not used.
Pan head screw (M3×8)
2. WIRING
Flat washer
Control unit
cable
2-9
Advertisement
Table of Contents
