Table of Contents
Advertisement
Item
[Time Zone]
3.2.4
KP control setting
Set the KP control signals at [TX Triggering] on the [Shared Settings] menu. The po-
larities for KP input and output are positive.
Note: External KP levels are follows:
• Input: 5 V to 12 V
• Output: 12 V
[TX
Triggering]
3.2.5
Water temperature source setting
Set the water temperature source at [Temp Source] on the [Shared Settings] menu.
Item
[Temp Source]
Setting value
Select the appropriate time zone.
Note: System reboot is required to apply the settings. The following
confirmation message appears. Click the [Yes] button to reboot the
system. A buzzer sounds during the system reboot because the com-
munication between the processor unit and the trackball control unit is
disconnected temporarily. The buzzer is stopped after completing the
system reboot.
Item
Setting value
[In Trigger]
[Off] (default),
[On]
[External
[0] to [200]
Trigger
(default: [0])
Delay]
Setting value
[NMEA] (default)
[External E/S
Water Tempera-
ture sensor]
[External
Transducer (HF)]
[External
Transducer (LF)]
Meaning
Select [On] to input the external KP
control.
Set the delay for the external KP, 0 to
200 (ms).
Meaning
Signal from the connected equipment.
Temperature sensor connected to external
sounder.
Temperature sensor in the external sounder's
high frequency transducer.
Temperature sensor in the external sounder's
low frequency transducer
3. INITIAL SETTINGS
Meaning
3-5
Advertisement
Table of Contents
