Dvi/Usb Repeater (Option) - Furuno FCV-38 Installation Manual

2.6

DVI/USB Repeater (Option)

You can install the processor unit apart from the monitor unit and USB device by using
the optional DVI/USB repeater. Cable extension without the repeater can result in sig-
nal loss and incorrect data display.
To access the connectors on the transmitter and re-
ceiver units, unfasten five screws and remove the
protective cover. For the connections between the
units, see the following connection diagram.
Note 1: Make sure that the power to all components
is turned off at the switchboard BEFORE connecting
the DVI/USB repeater.
Note 2: The DVI/USB repeater uses DC power. If
your vessel has AC power, a rectifier is required.
*2
Ground wire
IV-1.25sq.
Ship's ground
Monitor Unit
USB Device
(Max. 2 units)
The LAN and USB cables must be fastened to the cable clamp, using a cable tie (sup-
plied locally).
After wiring, reattach the protective cover.
Note: The cable clamp for the USB and LAN cables can be adjusted to accommodate
the connectors of those cables. See the following figure.
*1
WO2511 , 30 m
*1
WO2512 , 50 m
WO2513 *1 , 100 m
Receiver Unit
DVI-D
Ground wire
IV-1.25sq.
12-24 VDC
Not used.
Transmitter Unit
*2 DVI-D
Ship's ground
*1*4
HDMI-TO-DVI-L ,
5.3 m
*1
RNS-08-132 , 5 m
Processor Unit
2. WIRING
Protective cover
: Screws for protective cover
Not used.
MJ-A3SPF0024-035C
3.5 m
12-24 VDC
*1 : Option
*2
: Local supply
*3 : Maximum 5 m length
*4
: Maximum 5.3 m length
*1
,
2-13