Installing Half-Duplex To Full-Duplex Converters In A 3-Slot Modular Shelf; Mounting A Half-Duplex To Full-Duplex Converter On A Flat Surface; Mounting A Half-Duplex To Full-Duplex Converter On A Wall - Extreme Networks ExtremeSwitching 5520 Series Hardware Installation Manual

Installing Expansion Modules

Installing Half-Duplex to Full-Duplex Converters in a 3-Slot Modular Shelf

Refer to Installing a Half-Duplex to Full-Duplex Converter
Half-Duplex to Full-Duplex Converter.
Before installing the converter in the 3-slot modular shelf (part no. STK-RPS-1005CH3), mount the shelf
in the rack. Follow the steps in the
To install up to three Half-Duplex to Full-Duplex Converter units in the 3-slot modular shelf, follow these
steps:
1. Attach the four rubber feet (included) to the bottom of the converter, one at each corner.
2. Set the converter on the shelf.
3. Connect the converter to its power adapter, following the instructions in
to Full-Duplex Converter to its Power Adapter
4. Secure the converter to the shelf using cable ties (included with the shelf).
Pass the ties through the holes in the shelf and secure them firmly around the converter.
5. Connect the full-duplex ports (FD1 - FD4) to the switch.
6. Connect the half-duplex ports (HD1 - HD4) to your half-duplex devices.
7. Install one or two additional Half-Duplex to Full-Duplex Converter units in the shelf, as described in
steps 1

Mounting a Half-Duplex to Full-Duplex Converter on a Flat Surface

Refer to Installing a Half-Duplex to Full-Duplex Converter
Half-Duplex to Full-Duplex Converter.
To install a Half-Duplex to Full-Duplex Converter unit on a flat surface, follow these steps:
1. Attach the four rubber feet (included) to the bottom of the converter, one at each corner.
2. Set the converter on a flat, stable surface.
3. Connect the converter to its power adapter, following the instructions in
to Full-Duplex Converter to its Power Adapter
4. Connect the full-duplex ports (FD1 - FD4) to the switch.
5. Connect the half-duplex ports (HD1 - HD4) to your half-duplex devices.

Mounting a Half-Duplex to Full-Duplex Converter on a Wall

Refer to Installing a Half-Duplex to Full-Duplex Converter
Half-Duplex to Full-Duplex Converter.
To mount a Half-Duplex to Full-Duplex Converter unit on a wall, follow these steps:
1. Drill two holes in the wall, each 4 mm (0.16 in.) in diameter.
The holes should be 10.5 cm (4.13 in.) apart so that they correspond to the locations of the holes in
the bottom of the converter.
2. Insert an anchor bolt (not provided) into each hole in the wall.
3. Place a screw (not provided) into each anchor bolt and tighten so that the screw head protrudes
slightly from the wall.
3-Slot Modular Shelf Quick Reference
on page 109 through 4.
ExtremeSwitching 5520 Series Hardware Installation Guide
Installing Half-Duplex to Full-Duplex Converters in a 3-
on page 108 for installation options for the
on page 110.
on page 108 for installation options for the
on page 110.
on page 108 for installation options for the
Slot Modular Shelf
Guide.
Connecting a Half-Duplex
Connecting a Half-Duplex
109