Extreme Networks ExtremeSwitching 5520 Series Hardware Installation Manual page 117

Replacing AC Power Supplies
4. Carefully slide the power supply the rest of the way out of the switch.
5. Verify that the replacement power supply is oriented the same way as the unit you removed, and has
the same airflow direction.
6. Carefully slide the power supply all the way into the power supply bay.
See Figure
Figure 83: Installing an 1100 W AC Power Supply
7. Push the power supply in until the latch snaps into place.
Caution
Power supplies can become very hot during operation. Wear thermal protective gloves
when you remove a power supply from an operating switch.
Note
If you are not installing a replacement power supply, install a cover over the unoccupied
power supply bay. Unoccupied bays must always be covered to maintain proper system
ventilation and EMI levels.
83.
Caution
Do not slam the power supply into the switch.
ExtremeSwitching 5520 Series Hardware Installation Guide
Replace an 1100 W AC Power Supply
117