Install A Versatile Interface Module In A 5520 Series Switch - Extreme Networks ExtremeSwitching 5520 Series Hardware Installation Manual

Installing Expansion Modules

Install a Versatile Interface Module in a 5520 Series Switch

This section describes how to install a versatile interface module (VIM) in the front slot of a 5520 Series
switch.
You need the following tools and materials to install a VIM:
•
ESD-preventive wrist strap
•
Flat head screwdriver
Caution
Extreme Networks VIMs are not hot-swappable. Disconnect power to the switch before
removing an installed VIM or installing a new VIM.
To install a versatile interface module, follow these steps:
1. Attach the ESD wrist strap to your wrist and connect the metal end to an appropriate ground point
on the rack.
2. Ensure that the switch is completely powered down.
3. Using two fingers, remove the cover plate from the VIM slot.
a. Squeeze the sides to release the plate, and pull down from the top to open. The plate will remain
attached at the bottom.
Figure 78: Removing a slot Cover Plate (VIM slot cover shown)
4. Remove the new VIM from its anti-static packaging.
5. Install the VIM in the switch:
a. Carefully slide the VIM module into the switch.
b. Insert and tighten the retaining screws you previously removed, using the screws provided.
Figure 79: Tighten Screws on the Inserted VIM Module
Install a Versatile Interface Module in a 5520 Series
ExtremeSwitching 5520 Series Hardware Installation Guide
Switch
111