Adjusting The Black Mark/Die Cut Sensor; Printing - Avery Dennison Monarch 9416 XL Equipment Manual

A d j u s t i n g t h e B l a c k M a r k / D i e C u t S e n s o r
The printer has a black mark/die cut sensor, which it uses
to sense and properly calibrate supplies. Black mark
supply has sense marks (black marks) on the back of
them. Die cut supply does not have any black marks.
For die cut supplies, make sure the sensor is in the
detented position and the middle of the square lens lines
up with the arrow inside the printer.
For black mark supplies, if necessary, move the sensor to the left or right, depending
on where the black marks are on the supplies. The black marks on the supply should
cover the square lens inside the sensor.
P r i n t i n g
Before you print, make sure the printer is connected to the host with a communication
cable. The communication values at the printer must match those at the host.
The printer's default communication values are 9600 Baud, 8-bit data frame, 1 stop
bit, no parity, and DTR flow control.
1. Turn on the printer.
2. Download a format and a batch. Refer to the Packet Reference Manual for
information on downloading print jobs.
The printer prints the labels, either in peel mode or non-peel mode.
3.
Remove the printed labels.
4.
2-10 Equipment Manual
Sensor set for
Die Cut Supplies
Die Cut Black Mark