Hardware Installations And Upgrades; Before You Begin; Tools And Supplies Needed; System Reference - Intel H2000WP Series Service Manual

Hardware Installations and Updates

2 Hardware Installations and Upgrades

Before You Begin

Before working with your server product, pay close attention to the
at the beginning of this manual.
Note: Whenever you service the system, you must first power down the server and unplug all peripheral
devices and the AC power cord.

Tools and Supplies Needed


Phillips* (cross head) screwdriver (#1 bit and #2 bit)

Needle nosed pliers

Anti-static wrist strap and conductive foam pad (recommended)

System Reference

All references to left, right, front, top, and bottom assume the reader is facing the front of the
chassis as it would be positioned for normal operation.
®
Note: The Intel Server System H2000WP is shown for illustration purposes; server components with the
product family are identical.

Cable Routing

®
The Intel Server System H2000WP family is a high density system, containing four identical
Compute Nodes inside. There are a few cables for chassis internal routing. Each Compute Node
is installed in tray and can be hot swapped without any impact to other nodes.
When you add or remove components from Compute Node tray, make sure your cables are routed
correctly before plug in the node tray back to chassis. Use caution to make sure no cables or wires
are pinched and that the airflow from the fans is not blocked. Use the figures below to determine
the correct cable routing.
14
Safety Information on page
®
Intel Server System H2000WP Family Service Guide
iii