Chapter 3: Hardware Installations And Upgrades; Before You Begin; Tools And Supplies Needed; System References - Intel R1304BTSSFAN Service Manual

3
Hardware Installations and
Upgrades
Caution: No components in the Intel
swappable. Before removing or installing any component in this server system, you must
first take the server out of service, turn off all peripheral devices connected to the system,
turn off the system by pressing the power button, and unplug the AC power cord from the
system or wall outlet.
Note: Some components in the Intel
are noted as such (where applicable) in the following instructions.
Note: Most of the illustrations in this chapter show the Intel
with an optional optical drive installed. Unless otherwise noted, the instructions for
removing and installing components are the same for the Intel
R1304BTSSFAN/R1304BTLSHBN. When instructions differ, separate illustrations are
shown for the Intel

Before You Begin

Before working with your server product, pay close attention to the
on page

Tools and Supplies Needed

•
Phillips* (cross head) screwdriver, #1 bit and #2 bit
•
Antistatic wrist strap and conductive foam pad (recommended)

System References

All references to the left, right, front, top, and bottom assume the reader is facing the front
of the server system as it would be positioned for normal operation.
®
Intel Server System R1304BTSSFAN/R1304BTLSFAN/R1304BTLSHBN Service Guide
®
Server System R1304BTSSFAN/R1304BTLSFAN are hot-
®
®
Server System R1304BTSSFAN or R1304BTLSHBN.
iii.
Server System R1304BTLSHBN are hot-swappable and
®
Server System R1304BTLSFAN
®
Server System
"Safety Information"
27