Table of Contents
Advertisement
them. The Cycle Key is defaulted in the Cycle 1 position that normally activates all features to be
visible on the display. By hitting the Cycle Key once, Cycle is activated and hitting it a secnd time
activates Cycle 3, one last Cycle key activation and the display is back to Cycle 1.
To set user preferences for the Cycle Key:
'MENU' + "SELECTIVE DISPLAY" + 'ENTER'
The Cycles appear in the first three columns and are labeled 1, and 3. In order to adjust at which
Cycle features appear, use the Cursor Control key to highlight an item and hit 'ENTER' to remove
the item from appearing. Hit ENTER again to check the item so that it will appear on the display
when that Cycle is activated. Continue to use this procedure to activate features in Cycles 1 - 3 as
desired.
2.2 tURNING thE EKP-IV oN/oFF
Before powering On the EKP-IV, check for the correct voltage (10-35 Volt DC).
2.2.1 turning on
Press and hold 'POWER' for 1 second. The EKP-IV emits one rapid beep sound and a Title page
containing information about the Product name, Software version, library version and cartridges
installed is displayed. This data can also be viewed in the "About" page in the "Main Menu".
Fig. 2.2.1 - Title page
18
Advertisement
Table of Contents
