Waypoint Handling - AvMap EKP-IV PRO User Manual

cursor key enter the Distance for the line to extend and press 'ENTER'. To remove a radial, select
the object icon or the radial line with the cursor, then:
>'ENTER' + "PROJECT RADIAL" + 'ENTER'
A Warning message appears asking if you would like to remove the radial. Press 'ENTER' to confirm
or 'CLEAR' to exit. To remove all radials stored in the EKP-IV (see also Par. 14.9):
>'MENU' 1 sec. + "SYSTEM SETUP" + 'ENTER' + "CLEAR ALL RADIALS" + 'ENTER'
3.4.4 A - B Function
The A-B Function allows you to calculate distance and bearing between two specified points ("A"
and "B"). The distance and bearing will appear in the A-B data field box at the top of the screen.
(This must be selected for display; see Data Window, Par. 3.). To measure two points:
>Place the cursor at first position "A" + 'ENTER' + "A-B FUNCTION" + 'ENTER'
>Place the cursor at second position "B" + 'ENTER' + "A-B FUNCTION" + 'ENTER'
You can also measure distance from the current fix position using the A-B feature. From Home or
Auto Zoom mode:
>'ENTER' + "A-B FUNCTION" + 'ENTER'
This will place "A" at the current fix position, then:
>Place the cursor at second position "B" + 'ENTER' + "A-B FUNCTION" + 'ENTER'
This line will remain on the screen until it is deactivated. To deactivate:
>'ENTER' + "A-B FUNCTION" + 'ENTER'

3.4.5 Waypoint handling

Associate Waypoint with User Waypoint Alarm: When editing the waypoint, select the icon for the
waypoint. Any Waypoint with this icon will activate a user Waypoint Arrival Alarm if this feature is
turned on in the System Setup - Alarm Setup Menu.
The EKP-IV provides storage for 1000 Waypoints. These can be a combination of User Waypoints or
Flight Plan Waypoint storage. User Waypoints can be edited, searched and used as Waypoints within
a Flight Plan. User Waypoints can be created from the Moving Map screen or via the Database page
(see Database, Chapter 8 for entering Waypoints from the Database).
Add Waypoint
>Place the cursor at position + 'ENTER' + "ADD WAYPOINT" + 'ENTER'
Edit Waypoint
>Place the cursor over Waypoint + 'ENTER' + "EDIT WAYPOINT" + 'ENTER'
The Edit Waypoint box will appear. Using the cursor key scroll through the alphanumerics to create
an eight character name, adjust the Latitude or Longitude or select an icon. Press 'ENTER' within
each character field to move to the next field. After completing the icon selection, the box will
close and the new data is stored. Remove Waypoint (present only if there is a Waypoint under the
cursor position):
6