Approach From The Moving Map; Approach From Flight Plan Database - AvMap EKP-IV PRO User Manual

9 APPRoACh DAtA PRoCEDURES
WARNING!!!
The EKP-IV is not certified for use as the only navigation device during Instrument Flight Rules as established by the
FAA. Instrument approach points displayed in the unit are for information only and do not establish authority for
a pilot to fly the IFR approach procedure in actual instrument flying conditions. For IFR flight. The final "Approach
Segment & Missed Approach Point" the EKP-IV is to be used strictly as a monitoring instrument only.
An approach procedure is a series of pre-determined maneuvres for the orderly transfer of an
aircraft, under instrument flight conditions, from the beginning of the initial approach to a point
from which a safe landing may be made visually. Generally, the approach pattern and procedure is
not chosen until arrival in close proximity of the destination airport, since conditions may change on
route. To activate an "Approach" it is necessary to have an active "Flight Plan" or "GOTO".
For each airport with at least one published final approach, there exists one or more named
approach procedures. Each approach procedure can be related to a runway and to nearby NavAids
(such as ILS, VOR, NDB, GPS...).

9.1 APPRoACh FRoM thE MoVING MAP

Note
You must start with an empty flight plan.
While navigating or planning in the moving map screen, the pilot will not be able to establish an
approach on a flight plan, without changing into the Flight Plan mode, but can place the cursor over
the selected airport. To display the quick data box press:
> 'ENTER' 1 sec + 'ENTER' (for detailed information).
The detailed information on the airport will be displayed, beginning with the general information
and frequencies. By pressing the cursor key on the left, the approaches for the chosen airport will
display in the box and the bearing for the viewed approach will display on the moving map. By
continuing to press the cursor key on the left the other approaches for the airport will display, the
last bearing for the last approach viewed will become white on the moving map and the bearing for
the viewed approach will be displayed in black on the moving map.
Note
The white approach bearings will disappear once the screen redraws itself.

9.2 APPRoACh FRoM FLIGht PLAN DAtABASE

Refer to Chapter 6 for Flight Planning.
Flight Plan mode allows the pilot to plan and activate up to ten flight plans with up to 100 individual
legs each. Now the EKP-IV allows the pilot to pre-program an approach at the destination end of
the flight plan and to change the approach as desired.
Once an airport is present as a final waypoint in the flight plan, press 'MENU' and "SELECT
APPROACH" + 'ENTER' and the available approaches for the destination airport will be displayed.
Highlight the approach desired, press 'ENTER' and the waypoints associated for that approach will
show in the flight plan list. Press 'CLEAR' + 'CLEAR' and the flight plan will appear on the moving
map.
54