Device Setup - Austin Hughes Electronics Cyberview NCP-1716 User Manual

2.8 Device Setup

2.1.2 Setup the IP address from Ethernet port
In addition to VT100 interface, we also provide a Network Setup Software tool (IPCS Setup)
for the network settings to the IP serial console.
The operation procedures are as follows:
1. Run the software tool IpcsSeeker.exe
2. Click Search Devices to find out the IP serial console devices on the network. After few seconds, the MAC
addresses of found devices will show on Device MAC address field.
3. Select the MAC address on Device MAC address, then click Query Device to get the device configuration
on the right pane.
4. If you want to change the settings. Enter the Super user name & password. Change the settings on the right
pane. Then click Update Device. The new settings will be save to the IP serial console unit, then the unit will
be reboot automatically.
. Access IP serial console
Using the HTTP protocol and entering the confi gured IP address of IP KVM switch into the web browser
to remote access the IP KVM switch.
With successful connection to IP KVM, the login page will show as below, then key in the default user
name & password When connecting to the IPCS unit, the IPCS system (web server, Telnet server or
SSH server) will prompt user to enter the user name and password in order to access to the system.
There are two levels of access privileges:
User
Name
root
(user define)
The administrator can add or remove a user easily
via the web pages of System administration.
Default Access
Password Privileges
root Full access
(user define) Limit access to
serial port
P.27
Chapter 2