Austin Hughes Electronics Cyberview NCP-1716 User Manual page 22

2.4 Changing Operating Parameters
------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
F4 Comm SETUP Menu
------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
Baud Rate
Rcv Hndahake
Data / Stop Bits Preset with "8/1", changing the parameter will cause the local acess console
Xmt Hndshake
Parity
Comm Mode
Printer
Selection
Ethernet Mode
Multiple
Sessions
------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
F5 Misc SETUP Menu
------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
Wprt Intensity
Block End
Wprt Reverse
Wprt Underline Sets the write-protected characters to appear underlined.
Ptr Baud Rate
Ptr Data /
Stop Bits
Ptr Parity
Ptr Xmt
Hndshake
Ptr Rcv
Hndshake
Preset with "9600", changing the parameter will cause the local acess console
malfunction
Preset with "None", changing the parameter will cause the local acess console
malfunction
malfunction
Preset with "None", changing the parameter will cause the local acess console
malfunction
Preset with "None", changing the parameter will cause the local acess console
malfunction
Preset with "FDX", changing the parameter will cause the local acess console
malfunction
This setting is not support in this model
This setting is not support in this model
This setting is not support in this model
Normal, blank , dim, blank/dim.
Causes the terminal to send a block of data to the computer with a line terminator as
an ASCII US character and block terminator as an ASCII CR character (US / CR), or
with line terminators as ASCII CR and LF characters and the block terminator as an
ASCII ETX character (CRLF / ETX).
Sets the write-protected characters to appear in reverse
(dark characters on a light background).
Sets the SERIAL 2 port baud rate to 75, 150, 300, 600, 1200, 2400, 4800, 7200, 9600,
19200, 38400, 57600, 76800, 115200, 230400, 460800.
Through the SERIAL 2 port ,the terminal to send and receive 8-bits data with one stop bit
or two stop bits, or 7-bits data with one stop or two stops bits.
Causes the terminal to send the data to the SERIAL 2 port with none, odd, mark, even,
or space parity.
None, DSR, Xon / Xoff, Both .
None, DTR, Xon / Xoff, DTR/Xoff .
P.18
Chapter 2