Kubota K008-3 Workshop Manual page 323

When press fit the dust seal and oil seal, use
socket ans tap in with hammer.
(8) Thoroughly clean flange mounting screw
holes of housing, remove grease and apply
screw-locktite slightly. (S-280 and S-380
dose not require this job.)
(10)Clamp at housing with vise and tighten 4
bolts. (Tightening torque 25.5 ~ 31.4N·m
(2.6 ~ 3.2kg·m))
(7) Fit O-ring in flange.
(9) Mount flange into housing saay.
Care should be taken not to damage seal
with shaft key.
(11) Clamp with vise at flange and put O-ring on
housing.
IV-S-67
Courtesy of Machine.Market