Table of Contents
Advertisement
Figure 68. Removing the front mounting front PERC module
Next steps
1.
Replace the front mounting front PERC
Installing the front mounting front PERC module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3.
Remove the backplane
4. If installed,
remove the air
5. Route the cable properly to prevent the cable from being pinched or crimped.
Steps
1. Align the front PERC module at an angle until the tray touches the slot in the system.
2. Slide and press the front PERC module connector with the connector on the drive backplane until firmly seated.
3. Using a Phillips #2 screwdriver, tighten the captive screws on the front PERC module.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
module.
Safety
instructions.
Before working inside your
cover.
shroud.
system.
Installing and removing system components
69
Advertisement
Table of Contents
