Figure 113. Installing the Serial COM port
Next steps
1. Reconnect the serial COM port cable to the connector on the rear I/O board.
2.
Install the expansion card
3. Follow the procedure listed in
Optional IDSDM module
Removing the IDSDM module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If you are replacing the IDSDM module,
NOTE:
Temporarily label each SD card with its corresponding slot number before removal. Reinstall the SD cards into
the corresponding slots.
Steps
Holding the blue pull tab, lift the IDSDM module out of the system.
138
Installing and removing system components
riser.
After working inside your
Safety
instructions.
Before working inside your
remove the MicroSD
system.
system.
cards.