Figure 115. Installing the IDSDM module
Next steps
1.
Install the MicroSD
cards.
NOTE:
Reinstall the Micro-SD cards into the same slots based on the labels you had marked on the cards during
removal.
2. Follow the procedure listed in
MicroSD card
Removing the MicroSD card
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the IDSDM
module.
Steps
1. Locate the MicroSD card slot on the IDSDM module, and press the card to partially release it from the slot. For more
information about the slot location, see
2. Hold the MicroSD card, and remove it from the slot.
NOTE:
Temporarily label each MicroSD card with the corresponding slot number after removal.
140
Installing and removing system components
After working inside your
Safety
instructions.
Before working inside your
System board jumpers and connectors
system.
system.
section.