Figure 69. Installing the front mounting front PERC module
Next steps
1. Reconnect all the required cables.
2. If removed,
install the air
3.
Install the drive backplane
4. Follow the procedure listed in
Removing the rear mounting front PERC module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the backplane
4. If installed,
remove the air
5.
Remove the drive
backplane.
6. Disconnect all the cables, observe the cable routing.
Steps
1. Using a Phillips #2 screwdriver, loosen the captive screws on the front PERC module.
2. Slide the front PERC module to disengage from the connector on the drive backplane.
70
Installing and removing system components
shroud.
cover.
After working inside your
Safety
instructions.
Before working inside your
cover.
shroud.
system.
system.