Table of Contents
Advertisement
Figure 28. 8 x 2.5-inch with NVMe and GPUs
RIO card
Removing the Rear Input Output (RIO) card
Prerequisites
1. Follow the safety guidelines listed in the
Safety
instructions.
2. Follow the procedure listed in the
Before working inside your
system.
3.
Remove the system
board.
Steps
1. Using a Phillips #2 screwdriver, remove the screws that secure the RIO card to the system board.
2. Holding the edges, pull the RIO card to disconnect from the connector on the system board.
Installing and removing system components
33
Advertisement
Table of Contents
