Installing the serial COM port
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3.
Remove expansion card
4. Disconnect the serial COM port cable from the connector on the rear I/O board.
Steps
1. Open the latch on the expansion card riser and remove the filler bracket from the expansion card riser (Riser 3).
Figure 112. Installing the Serial COM port
2. Slide the serial COM port into the expansion card riser.
3. Connect the serial COM port cable to the serial port.
Safety
instructions.
Before working inside your
riser.
system.
Installing and removing system components
137