Installing A Power Supply Unit - Dell EMC PowerEdge R7525 Installation And Service Manual

Figure 140. Removing a power supply unit
Next steps
1. Replace the PSU or install the PSU

Installing a power supply unit

Prerequisites
1. Follow the safety guidelines listed in the
2. For systems that support redundant PSU, ensure that both the PSUs are of the same type and have the same maximum
output power.
NOTE: The maximum output power (shown in watts) is listed on the PSU label.
3. Remove the PSU blank.
Steps
Slide the PSU into the PSU bay until the release latch snaps into place.
160 Installing and removing system components
blank.
Safety instructions.