Table of Contents
Advertisement
Steps
1. Disconnect the control panel cable from the connector on the system board.
2. Using the Phillips #1 screwdriver, remove the screws that secure the left control panel and the left control panels cable
cover to the system.
3. Hold the left control panel cable, and slide the left control panel out of the system.
NOTE:
Observe the routing of the cable as you remove the right control panel from the system.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 39. Removing the left control panel
Next steps
1.
Replace the left control
Installing the left control panel
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
Steps
1. Align and slide the left control panel in the slot on the system.
2. Connect the left control panel cable to the connector on the system board .
3. Route the left control panel cable through the side wall of the system. Align and slide the left control panel cable cover in the
slot on the system.
NOTE:
Route the cable properly to prevent the cable from being pinched or crimped.
44
Installing and removing system components
panel.
Safety
instructions.
Before working inside your
system.
Advertisement
Table of Contents
