SMC Networks ISA3 Series Operation Manual page 46

■Measurement mode
Placement verification screen (Main display)
The Placement condition is indicated by the switch output status (ON/OFF).
Level meter (Sub display)
Element
Switch point value bar
Level meter
○Relationship between the display and the placement status
(e.g.: hysteresis mode, reversed output)
・
・
・
Placement surface
(Detection nozzle)
When OUT1 is set to hysteresis mode, the bar equivalent to the switch point, which has
been set as the set value of OUT1, is displayed automatically.
: OUT1 switch point only When OUT1 is set to window comparator mode, the bar will not be
displayed.
The workpiece gap condition approaching the nozzle is indicated by the number of "
displayed.
This display is a reference only. It is not an accurate distance measurement.
Display
Level meter " " is
not displayed.
Switch point value
bar "- -" and level
meter " " are not
close.
Switch point value
bar "- -" and level
meter " " are
close.
Level meter " "
has reached
switch point value
bar "- -".
Level meter " "
reaches its
maximum.
: For normal output, the switch point is displayed on the left side.
Description
Placement status
Detection surface
and the workpiece
are very distant.
Detection surface
and the workpiece
are too far apart.
Detection surface
and the workpiece
are slightly apart.
Workpiece is
placed on the
detection surface.
Workpiece is in
close contact with
the detection
surface.
-45-
4 How to use
"
.
Switch output
Switch output is OFF.
Switch output is OFF.
Switch output is OFF.
Switch output is ON.
Switch output is ON.
No.PS※※-OMW0009-A